Peerless Industries PF630 사용자 설명서

ISSUED: 11-19-07 SHEET #: 202-9247-5 09-21-09

Use a stud finder to locate the edges of the stud. Use of an edge-to-edge stud finder is highly recommended.

Based on its edges, draw a vertical line down the stud’s center. Place wall plate (

A) on wall as a template, making

sure that the two mounting holes are on the stud centerline. Level wall plate, and mark the center of the two holes.

Drill two 5/32" (4 mm) dia. holes 2.5" (64 mm) deep. Make sure that the wall plate is level, secure it using two #14 x

2.5" wood screws (

D) as shown.

WOOD STUD

•  Installer must verify that the supporting surface will safely support the combined load of the equipment and all

attached hardware and components.

•  Tighten wood screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the

screws, greatly reducing their holding power.

•  Never tighten in excess of 80 in. • lb (9 N.M.).
•  Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud finder

is highly recommended.

•  Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Install-

ers are responsible to provide hardware for other types of mounting situations (not evaluated by UL).

1