Peerless Industries PF630 사용자 설명서

ISSUED: 11-19-07 SHEET #: 202-9247-5 09-21-09

Make sure that wall plate (

A) is level, use it as a

template to mark two mounting holes. Drill two 5/16"

(8 mm) dia. holes to a minimum depth of 2.5"

(64 mm). Insert anchors (

E) in holes flush with wall

as shown. Place wall plate over anchors and secure

with two #14 x 2.5" screws (

D). Level, then tighten

all fasteners.

CINDER
BLOCK

SOLID
CONCRETE

1

•  When installing Peerless wall mounts on cinder block, verify that you have a minimum of 1-3/8" (35 mm) of actual

concrete thickness in the hole to be used for the concrete anchors. Do not drill into mortar joints! Be sure to mount

in a solid part of the block, generally 1" (25 mm) minimum from the side of the block. Cinder block must meet ASTM

C-90 specifications. It is suggested that a standard electric drill on slow setting is used to drill the hole instead of a

hammer drill to avoid breaking out the back of the hole when entering a void or cavity.

•  Concrete must be 2000 psi density minimum. Lighter density concrete may not hold concrete anchor.
•  Make sure that the wall will safely support four times the combined load of the equipment and all attached hardware

and components.

Drill holes and insert anchors (

E).

Place plate (

A) over anchors (E) and secure with screws (D).

Tighten all fasteners.

concrete

surface

wall

plate

wall

plate

plaster/

dry wall

plaster/

dry wall

concrete

concrete

•  Tighten screws so that wall plate is firmly attached,

but do not overtighten. Overtightening can damage

screws, greatly reducing their holding power.

•  Never tighten in excess of 80 in. • lb (9 N.M.).
•  Always attach concrete expansion anchors directly

to load-bearing concrete.

•  Never attach concrete expansion anchors to

concrete covered with plaster, drywall, or other

finishing material. If mounting to concrete surfaces

covered with a finishing surface is unavoidable,

the finishing surface must be counterbored as

shown below. Be sure concrete anchors do not

pull away from concrete when tightening screws.

If plaster/drywall is thicker than 5/8" (16 mm),

custom fasteners must be supplied by installer (not

evaluated by UL).