Peerless Industries SUF640P 사용자 설명서

ISSUED: 05-29-08  SHEET #: 202-9281-7   12-14-09

Wall plate (A) can be mounted to two studs that are 16" apart. Use a stud finder to locate the edges of the studs. 
Use of an edge-to-edge stud finder is highly recommended. Based on their edges, draw a vertical line down each 
stud’s center. Place wall plate on wall as a template. The mounting slots should be located 7" (177 mm) above the 
desired screen center as shown in figure 1.1. Level plate, and mark the center of the two mounting holes. Make 
sure that the mounting holes are on the stud centerlines. Drill two 5/32" (4 mm) dia. holes 2" (51 mm) deep. Make 
sure that the wall plate is level, secure it using two wood screws (C) as shown in fig. 1.2.

•  Installer must verify that the supporting surface will safely support the combined load of the equipment and all 

attached hardware and components.

•  Tighten wood screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the 

screws, greatly reducing their holding power.

•  Never tighten in excess of 80 in. • lb (9 N.M.).

•  Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud finder 

is highly recommended.

•  Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Install-

ers are responsible to provide hardware for other types of mounting situations (not evaluated by UL).

CENTER OF SCREEN

STUD

7" 

(177 mm)

NOTE: If mounting with in-wall box model IBA1 (not UL listed), allow bottom edge 
of wall plate (A) to touch top edge of in-wall box as shown below.

IN-WALL BOX

DRYWALL

IN-WALL BOX

WOOD STUD

WOOD STUD

1