Panasonic CZ-RWSC1U 작동 가이드

15

•  Point the transmitter of the remote controller at the receiver. When the signal is received correctly it 

will beep once. (It beeps twice only when the unit starts operating.)

•  The signal can be received at a distance of about 19 ft. This distance should be used only as a 

guide. It depends on battery strength.

•  Make sure nothing is between the remote controller and the receiver that could block the signal.
•  Do not leave the remote controller in direct sunlight, where the wind from the air conditioner can 

blow directly on it, or near any other heat source.

•  Take care not to drop, throw or wash the remote controller with water.
•  The signal from the remote controller may not be received in rooms with rapid start fl uorescent 

lighting, inverter lights, plasma displays, LCD televisions (monitor), etc. For more information, please 
contact the dealer where the product was purchased.

• Press   from the location you wish to mount the remote 

controller and make sure the signal is received correctly.

•  Pull the remote controller forward to remove it.

This may cause a malfunction.
Be sure to keep the remote controller in the same room as the receiver.

When the signal is received correctly it will beep one time.

Keep it out in the open.

 

 

1

2

Fasten the Remote 
Controller mount 
with screws.

Fitting the Remote 
Controller in the 
mount.

Remote Controller 
mount

Press

Put in

Instruction_eng.indd   15

Instruction_eng.indd   15

2012/01/27   16:25:34

2012/01/27   16:25:34