Honeywell UDC 3300 사용자 설명서
4/00
UDC 3300 Controller Product Manual
263
How to replace the
display/keyboard
assembly
display/keyboard
assembly
Refer to Figure 9-2 and follow the procedure listed in Table 9-17.
Table 9-17
Display/Keyboard Assembly Replacement Procedure
Step
Action
1
Remove the chassis from the case as shown in Figure 9-1.
2
Peel the rubber bezel and display window off the chassis assembly.
3
Separate the chassis frame at the four release points shown in Figure 9-2
and wiggle each printed wiring board out of its socket on the
display/keyboard assembly. Pull out slightly.
and wiggle each printed wiring board out of its socket on the
display/keyboard assembly. Pull out slightly.
4
Insert a small flat-bladed screwdriver into each of the display/keyboard
release points (Figure 9-2) and pry out the board.
release points (Figure 9-2) and pry out the board.
5
Install the new board, bottom end in first, and push in the top until it clicks
into place.
into place.
6
Reinstall the printed wiring boards into the rear of the display board
making sure that the boards click into their release points.
making sure that the boards click into their release points.
7
Replace the bezel and window assembly.
8
Reinstall chassis into case. Press in hard, then tighten the screw.
Figure 9-2
Display/Keyboard Replacement
Display keyboard
release points
release points
Pull printed
wiring boards
out slightly
wiring boards
out slightly
Printed wiring
boards
release points
boards
release points
Display/keyboard
Chassis assembly
Rubber bezel
and window
and window
22638