VXi VT1529A/B 사용자 설명서

1. Unlike the MEAS:VOLT:EXC? command, the individual command sequence 

above cannot keep defined algorithms from running at INIT. Since algorithms 
can place values into the FIFO buffer, it will be necessary to determine which 
FIFO values are the excitation voltages.

2. Remember that the MEAS:VOLT:EXC? command also provides the average 

of 32 measurements for each excitation value.

•

This command is only for use on channels measured with the VT1529A/B. If 

executed on channels connected to other strain SCPs, a 3007 "Invalid signal 
conditioning plug-on" error message will be generated

•

This command executes a measurement scan without running defined 

algorithms. This is to keep algorithms from placing values in the FIFO buffer.

•

The measurement sample interval is 392 µs

•

Filter settings and states are not changed by this command.

•

After completing the measurements, the instrument is re-configured to the same 

settings that existed before the command was executed.

•

When Accepted: Not while INITiated

•

Related Commands: SENSe:STRain:EXCitation, MEAS:VOLT:UNST?

•

*RST Condition: Channel excitation voltage values are not affected by *RST. 

However, *RST changes the function for all analog input channels to Voltage. 
When a strain channel is changed back to the strain function with a 
SENS:FUNC:STRAIN... command, the excitation voltage values for these 
channel will still be in effect. Of course, loss of power will cause the excitation 
values to be lost.

•

Returned Value: numeric, number of channel values in FIFO. The type is int16.

•

Send with VXIplug&play Function: hpe1422_cmdInt16_Q(...)

MEAS:VOLT:EXC? (@10000:10931)

SENS:DATA:FIFO:RESET

channel list (string)

10000 - 15731

none