VXi VT1529A/B 사용자 설명서

CALibration (continued)

:REMote?

Calibrates Remote Signal Conditioning Units

:DATA

Sends RSC cal constants from CAL:REM:DATA? back to VT1422A

:DATA?

Queries VT1422A for all remote cal constants

:STORe

Copies RSCU calibration constants from working ram to non-volatile memory

:SETup

Performs Channel Calibration procedure

:SETup?

Returns state of CAL:SETup operation (returns error codes or 0 for OK)

:STORe ADC | TARE

Store cal constants to non-volatile Flash RAM for either A/D calibration or 

those generated by the CAL:TARE command

:TARE (@<ch_list>)

Calibrate out system field wiring offsets

:RESet

Resets cal constants from CAL:TARE back to zero for all channels

:TARE?

Returns state of CAL:TARE operation (returns error codes or 0 for OK)

:VALue

:RESistance <ref_ohms>

Send to instrument the value of just measured reference resistor

:VOLTage <ref_volts>

Send to instrument the value of just measured voltage reference

:ZERO?

Correct A/D for short term offset drift (returns error codes or 0 for OK)

DIAGnostic

:CALibration

:SETup

[:MODE] 0 | 1

Set analog DAC output SCP calibration mode

[:MODE]?

Return current setting of DAC calibration mode

:TARe

[:OTD]

[:MODE] 0 | 1

Set mode to control OTD current during tare calibration

[:MODE]?

Return current setting of OTD control during tare calibration

:CHECksum?

Perform checksum on Flash RAM and return a '1' for OK, a '0' for corrupted 

or deleted memory contents

:CONNect <source>,<mode>,(@<ch_list>)

connect VT1529A/B channels to measure internal values for verification

:CUSTom

:MXB <slope>,<offset>,(@<ch_list>)

Generates and loads linear custom EU table

:PIECewise <table_ad_range>,<table_block>,(@<ch_list>)

Loads piecewise custom EU table

:REFerence:TEMPerature

Puts the contents of the Reference Temperature Register into the FIFO

:INTerrupt[:LINe] <intr_line>

Sets the VXIbus interrupt line the module will use

:INTerrupt[:LINe]?

Returns the VXIbus interrupt line the module is using

:OTDetect[:STATe] ON | OFF, (@<ch_list>)

Controls "Open Transducer Detect" on SCPs contained in <ch_list>

:OTDetect[:STATe]? (@<channel>)

Returns current state of OTD on SCP containing <channel>

:QUERy

:SCPREAD? <reg_addr>

Returns value from an SCP register

:TEST?

:REMote

:NUMber? <test_num>,<iterations>,(@<channel>)

Performs single selected self-test on RSCU a selected number of times

:SELFtest? (@<channel>)

Performs complete self-test on Remote Signal Conditioning Units

:VERSion?

Returns manufacturer, model, serial#, flash revision # and date

e.g., HEWLETT-PACKARD,E1422A,US34000478,A.04.00, 

Wed Jul 08 11:06:22 MDT 1994

FETCh?

Return readings stored in VME Memory (format set by FORM cmd)