Sprint Nextel 2 사용자 설명서

Installation and Operation 

7 

 

Note:  The telephone and telephone cord are not included. You must provide your own 

telephone and telephone cord. 

Note:  The device and telephone cord are for indoor use only. 

Note:  Only telephones connected directly to the Sprint Phone Connect 2 will receive service. If 

the Sprint Phone Connect 2 is connected to a cordless phone base station, any 

extension phones compatible with that base station will also receive service. 

Use the power button to turn the Sprint Phone Connect 2 on and off. 

►  To power the device on, press and hold the 

 button until power indicator turns on. 

►  To power the device off, press and hold the 

 button until all indicators turn off. 

Note:  For the first time you use the Sprint Phone Connect 2, wait 3-5 minutes for activation to 

finish or while LEDs are blinking green from right to left. Do not touch your Sprint Phone 

Connect 2 during this time. If after 5 minutes the LED lights are still blinking, power cycle 

your device using the power button. 

The four LED lights on the front of your device let you know your device’s status at any given 

time. 

Light 

White 

The device is on 

Solid Green 

Full Charge 

Blinking Green 

Partial Charge 

Blinking Red 

Low Charge 

Solid Red 

No Battery Charge 

Green 

With signal 

Off 

Without signal 

Green 

Good or Ok 

Red 

Poor or None 

Blinking Green 

New Message 

Blinking Green from Left to Right  The software is being updated