Sprint Nextel 2 사용자 설명서

Installation and Operation 

8 

 

Making calls with your Sprint Phone Connect 2 is as easy as making calls using traditional wired 

telephone service. 

1.  Before making a call, make sure signal and signal strength indicators are lit up. 

2.  Place a call by entering the desired telephone number. 

3.  When your call is complete, hang up or return the phone to the receiver to ensure that 

you can receive calls. 

If you are using a new telephone number with your Sprint Phone Connect 2, simply share your 

new number with friends & family. When they call, answer the phone connected to your Sprint 

Phone Connect 2 device. If you're using your existing number, simply answer the phone as 

usual when the phone rings. 

You can adjust the in-call volume in standby mode or during a call. Four volume levels are 

available, with level 1 being the lowest and level 4 the highest. 

The following steps illustrate how to adjust the in-call volume in standby mode. 

1.  Pick up the handset. 



  If you hear the dial tone, telephone service is available. 

2.  Enter 

# # 1 to adjust the in-call volume. 

3.  Press a key (

1-4) to select the desired volume level. 

4.  Press the 

* key to save the volume level. 



  If you hear the confirm tone "beep", you have successfully set the volume level. 



  If you hear the dial tone again, the device has returned to the off-hook state, and you 

can proceed to configure other settings. 

Note:  If you hear the reject tone "beep, beep", you have pressed an incorrect key and failed to 

adjust the in-call volume. Wait until the device returns to the off-hook state and you hear 

the dial tone again. Then repeat steps 

2-4 to adjust the in-call volume again.