Siemens MC55 사용자 설명서
MC55 AT Command Set
3.2 AT+CIND
s
m
obile
MC55_ATC_V01.05
Page 67 of 469
2/10/04
Confidential / Released
Command Description
The read command returns the status of the ME indicators.
The write command is used to switch the event report for each indicator type. The Indicator Event Reports are
displayed to the TE via "
displayed to the TE via "
" which can be enabled using
Parameter Description
Integer type value, which shall be in range of corresponding
ranges.
. Therefore use of
for control of all indications is recom-
mended.
The following indications are accessible via
The following indications are accessible via
“battchg“
Battery charge level 0..4 or 5 if no measuring is performed, e.g because no bat-
tery is connected. Also refer
tery is connected. Also refer
.
“signal“
Signal quality (0..7) or (99) if not measurable. The indicated value is the bit
error rate of the signal received. If there are bit errors this is not a constant but
a estimated value which will change in time. See also
error rate of the signal received. If there are bit errors this is not a constant but
a estimated value which will change in time. See also
.
“service“
Service availability (0-1)
0: Not registered to any network
1: Registered to home network or, if "roam"=1 then registered to another net-
work
0: Not registered to any network
1: Registered to home network or, if "roam"=1 then registered to another net-
work
“sounder“
Sounder activity (0-1). The indicator provides information about tones gener-
ated in the ME. Value 1 means for example:
Incoming call - ME is ringing. Note that the URC "
ated in the ME. Value 1 means for example:
Incoming call - ME is ringing. Note that the URC "
": "sounder" indicator
will be output only if ringing tones are activated with
.
Waiting call - ME generates waiting call tone (if call waiting is enabled).
Outgoing call - ME generates Call Progress tone.
Outgoing call - ME generates BUSY tone.
The value changes to 0 if tone stops
Outgoing call - ME generates Call Progress tone.
Outgoing call - ME generates BUSY tone.
The value changes to 0 if tone stops
“message“
Unread short message at memory location
(0-1); refer to
“call“
Call in progress (0-1). Indicator value is "1" if at least one call is in state "active"
or "held".
Depending on the value of
or "held".
Depending on the value of
), indica-
tor "call" will be issued
• when a state transition ends in state "active" or in state "unknown", if
• when a state transition ends in state "active" or in state "unknown", if
setting
="restricted",
• when any state transition (including transitions beginning or ending in state
PIN
ASC0
ASC1
MUX1
MUX2
MUX3
!
%
%
%
%
%
Reference(s)
GSM 07.07
<indValue>
(num)
<indDescr>
(str)