Tyco Electronics P5200 사용자 설명서

47 

Table 8-9 lists and defines the messages that may be displayed by the radio during a Selective Alert. 

Alert Sent 

Alert message successfully sent to target. 

Delivered 

Alert message passed to network. 

Delivering 

Delivering alert message to target. 

New alert 

New alert message received. 

No alerts 

No alerts are available. 

Busy 

VNIC congested and cannot deliver message at 
the current time. 

Dest Down 

Destination home VNIC down. 

Ignored 

Destination is either non-responsive or does not 
care to respond. 

Inv Option 

Distribution option is invalid. 

Not Reg 

Destination is not registered. 

Partial 

Not all destination ESN instances reachable. 

Unauth Alrt 

Unauthorized service function; initiator is not 
authorized to send the selected service message. 

Unknown Msg 

Unknown status received from VNIC. 

Unreachable 

Alert destination cannot be reached. 

The sending process has three steps. First select the destination radio’s User ID, then select the alert 
message, and finally send the message.  

1.  Using the keypad, enter *7. 

At the “AlertDst” prompt, enter the full User ID of the unit to send the message. A shortened User ID 
number can be dialed using the following guidelines: 

•  If the radio being called is in the same region and agency – enter only the last four digits. 
•  If the radio being called is in the same region, but a different agency – enter the last seven digits. 
•  If the radio being called is in another region or if the area is unknown – enter all ten digits. 

2.  Press the # key to activate the selection. 

3.  Use the 

 and 

 buttons or the 

 and 

 buttons to scroll through the available messages until 

the desired message is displayed. 

4.  Press the 

 or # key to send the message. 

5.  Observe Status Messages (Table 8-9) to ensure proper delivery.