Tyco Electronics P5200 사용자 설명서

83 

STATUS is selected you need to enter the number of the status message you intend to transmit. If no 
status has been programmed for the selected number key, the radio will display 

NO ENTRY

. A valid 

selection will permit the status text to appear in the display for a pre-programmed time. After the time-out 

expires or the 

 key has been pressed (the 

 key will override the time-out period), the status is selected 

and will be transmitted to the site or stored in the radio memory where it can be polled by the site at a 
future time. Status messages can also be programmed for single key operation so that a single press of a 
key assigned to a status message automatically transmits that message. If the site does not receive the 
status properly, the radio will sound a low pitched tone. 

The status selection can also be cancelled by pressing the CLEAR button prior to the time-out period.  

To view the currently selected status after it has been transmitted, press the 

 key and then the 

 key to 

ramp to STS, re-press the 

 key again and then the CLEAR button prior to the time-out period. If the 

status was not sent successfully to the site, the text associated with the status will flash in the display. 

Message Operation is performed in the same manner as status operation in the previous section. 

Dynamic Regroup Operation permits multiple talk groups (up to eight) to be added to a radio via the 
system manager. The radio must be pre-programmed to respond to regrouping. Dynamic regrouping will 
not be activated in a radio until the system manager sends an activation message. Each radio that receives 
and acknowledges the regrouping instructions is successfully regrouped.  

Pressing and holding the 

 button for 2.5 seconds toggles the user into and out of the dynamic regroup 

groupset. A double beep will sound for entry or exit. The display will indicate 

REGRP_0x

 where "x" is a 

digit of 1 to 8 indicating the group (when dynamic regroup has been enabled by the user). If the radio is in 
dynamic regroup and the user selects a group that has not been regrouped, the display will show 

NO 

ENTRY

. The radio will be prevented from transmitting and receiving calls in this condition except for 

scanned groups.  

If the pre-programmed groupset on the currently selected system contains an EMER/HOME group and 
the radio is in dynamic regroup, the radio will declare the emergency on the currently selected dynamic 
group. 

Macro key operation permits the user to accomplish a series of keystrokes with a single "macro" 
keystroke. Each Macro Key is capable of executing up to twenty (20) keystrokes, to any push button input 
(i.e., keypad keys, OPTION buttons, etc.). Each macro key can be pre-programmed to activate when 
pressed or when released.  

A macro key may also be pre-programmed to change the key stroke sequence the next time the macro key 
is activated.  

For detail operation and assignment of macro keys, contact your communications supervisor or 
administrator.