Tyco Electronics P5200 사용자 설명서

82 

3.  Press 

 to enter the overdial select/entry mode and follow the selection mode rules to call up a stored 

number from the phone list.   is displayed. Press PTT to send the overdial sequence once. If the 
number needs to be transmitted again it must be selected or entered again (this prevents unwanted 
numbers from being sent the next time the PTT button is pressed during the call). This overdial 

select/entry mode remains active until the call is dropped, cleared, or 

 is pressed. The overdial 

select/entry mode can be re-entered if the call is still active by pressing 

. 

1.  Follow the procedure in Section 9.24.2 to establish a connection to the telephone system or consult 

the system administrator for the procedure to access a dial tone on the trunked or conventional 
system.  

2.  Overdial numbers are transmitted using either method as follows: 

This overdial select/entry mode remains active until dropped, cleared, or 

 is pressed. The overdial 

select/entry mode can be re-entered if the call is still active by pressing 

. 

Individual Call ID numbers, telephone numbers and other number sequences for overdialing are stored in 
the special calls lists when programming the radio. The first ten entry locations of these lists can be 
changed by the radio operator. The keypad is used when adding, changing, and storing numbers in these 
entry locations.  

Use the following procedure to store a number in one of the first ten entries of a special call list:  

1.  Press 

 or 

 to enter the individual call list or the phone call list.   is displayed. 

2.  Scroll through the list using the 

 or 

 until one of the first ten entries is reached. 

NO ENTRY

 is 

displayed if the location is empty.  

3.  Enter the desired number. If necessary, a pause can be entered by pressing and holding 0-9, 

, or 

 until an underscore appears in the display (telephone interconnect only). The individual call list 

entries will accept up to 5 digits. The phone call list entries accept a combination of up to 31 digits 
and pauses.  

4.  Press and hold 

 until the display changes indicating that the number has been stored.  

Repeat steps 1-4 above if the number stored in an entry location needs to be changed. 

Status operation permits the transmission of a pre-programmed status condition to the P25 Trunked or 
EDACS site. Message operation permits the transmission of a pre-programmed message text to a P25 
Trunked or EDACS site. 

To send a status condition, press the 

 key followed by 

 or 

 key to select the pre-programmed 

status. STATUS and 0 through 9 pre-programmed status selections are available from the menu. If