JVC LST1108-001A 사용자 설명서

䡵 Error Message
If the white balance adjustment is not correctly completed, 
one of the following messages will appear for about 5 
seconds.

䡵 White Paint Adjustment

You can fine-tune the white balance saved in Memory A or 
Memory B.

* Adjust [White Paint R]/[White Paint B] in [Main Menu] B 

[Camera Process] B [White Balance] menu (A Page 85)

When [AWB] is selected, the normal white paint adjustment 
value is cleared. However, you can also set to keep the value 
even when [AWB] is executed. (A Page 85)

You can assign 

AFAWB (Fulltime Auto White balance) to any 

of the three positions on the [WHT.BAL.] selection switch. 
Configure the setting with [FAW] in the [Camera Function] B 
[SW Set] menu. (A Page 79)
Set the [FULL AUTO] switch on the camera recorder to 

AONB 

to enter FAW mode. White balance is automatically adjusted 
according to the color temperature of the lighting on the 
object.
White balance switching with the [WHT.BAL.] selection 
switch is disabled.

● When [White Balance] in the [Camera Function] B            

[FULL AUTO] menu is set to 

ASW SetB, you can switch 

the white balance with the [WHT.BAL.] selection switch on 
the camera recorder. (A Page 81)

● The accuracy of [FAW] is inferior to that of Auto White 

Balance.

● When the power of the camera recorder is turned on with 

the [FAW] mode selected, it takes about 15 seconds for 

the colors to stabilize.

NG : OBJECT

The object used is defective.
Displayed when there is not enough 
white color on the object, or when the 
color temperature is not suitable.
Use another white object and adjust 
the white balance again.

ERROR : LOW LIGHT

Insufficient illumination.
Displayed when the lighting is dark. 
Increase the lighting and adjust the 
white balance again.

ERROR : OVER LIGHT

Excessive illumination.
Displayed when the lighting is too 
bright. Decrease the lighting and adjust 
the white balance again.