JVC GR-D239 사용자 설명서

MasterPage: Start_Right

In some situations, 
different shooting 
angles may provide 
more dramatic results. 
Hold the camcorder in 
the desired position 
and tilt the LCD 
monitor in the most 
convenient direction. It 
can rotate 270° (90° 
downward, 180° 
upward).

During recording, a time code is recorded on the 
tape. This code is to confirm the location of the 
recorded scene on the tape during playback. 

* Frames are not displayed during recording.

If recording starts from a blank portion, the time 
code begins counting from “00:00:00” 
(minute:second:frame). If recording starts from 
the end of a previously recorded scene, the time 
code continues from the last time code number. 
If during recording a blank portion is left partway 
through the tape, the time code is interrupted. 
When recording is resumed, the time code starts 
counting up again from “00:00:00”. This means 
the camcorder may record the same time codes 
as those existing in a previously recorded scene. 
To prevent this, perform Recording From The 
Middle Of A Tape (

墌 pg. 19) in the following 

cases;

● When shooting again after playing back a 

recorded tape.

● When power shuts off during shooting. 

● When a tape is removed and re-inserted during 

shooting.

● When shooting using a partially recorded tape. 

● When shooting on a blank portion located partway 

through the tape.

● When shooting again after shooting a scene then 

opening/closing the cassette holder cover.

● The time code cannot be reset.

● During fast-forwarding and rewinding, the time 

code indication does not move smoothly.

● The time code is displayed only when “TIME 

CODE” is set to “ON”. (

Enables to check the end of the last recording.
1) Press 

 during the Recording-Standby 

mode.
2) Tape is rewound for about several seconds 
and played back automatically, then pauses in 
the Recording-Standby mode for the next shot.

● Distortion may occur at start of playback. This is 

normal.

1) Play back a tape or use Blank Search 
(

墌 pg. 20) to find the spot at which you want to 

start recording, then engage the Still Playback 
mode. (

2) Set the Power Switch to “A” or “M” while 
pressing down the Lock Button located on the 
switch, then start recording.

GR-D239PAL.book  Page 19  Friday, April 22, 2005  11:25 AM