Toshiba IK-WB01A 사용자 설명서

6) Plug in the camera

a) Confirm that the settings are the same as the wireless network

environment.

  ●

  When  any  settings  are  different  from  the  wireless  network

enviromment, set the same values.

b) Disconnect the LAN cable from the camera.
c) Unplug the camera once and plug it in again.

7) Confirm the camera connection

a) Ping the IP address set for the camera from a personal computer on

the network.

  ●

 Start a command prompt. Type as "ping n.n.n.n (IP address set for

camera)" and press "Enter" key.

   If the "Reply from..." message appears, the wireless connection is

correctly established.

・If a message other than the above appears:           

Start "Camera Finder" (→ page 34) and try performing a search.

●

 "Camera Finder" can find the camera even if the IP address of the camera

is incorrect (even if the wrong network address is specified).

 ●

 Check whether the IP address of the camera found is the one you set as

your network address.

・If "Camera Finder" was unable to find a camera, place the front of the

camera close to the antenna of the access point or wireless broadband
router and unplug the camera once and plug it again.