Veo 802.11b 사용자 설명서

Page 11 of 69 

network address is 192.168.0 and the camera display is showing 020, the IP address for the camera is 
192.168.0.20 (drop leading zeros). You can easily determine your network address by checking the IP address 
of any PC on the network or using the Observer Setup Utility. 
 

 

Before installing the Wireless Observer camera, you should set up your wireless access point/wireless 
broadband router or ad-hoc peer and verify that you can connect to it from a PC. To view the camera’s image or 
make any manual configuration changes, you will need a Windows PC with Internet Explorer 5.0 or higher, also 
connected to the LAN. 

 

 

 

 

 

 

 
 
 
 
 
 

 
Step 1.  Install and run the Observer Setup Utility included on the  

 CD-ROM. 

1.  Insert the CD and follow the installation directions. Refer to 

Chapter 4: PC Software Installation if you need help 
installing the software. 

2.  Click on the Veo Observer Setup  Utility icon 

 to run the 

program.  The screen shown on the right will appear 

Step 2. Click the “Wireless Setup” button. 

 

Using the IP display to determine your camera’s complete IP Address 

Step 3. Plug the other end of the serial 
cable into an open serial port on your 
PC. 

Step 2. Plug the serial cable into the port 
labeled RS232 at the back of the 
camera. 

Step 1. Connect the power supply to the 
back of the camera as shown, and then 
plug the supply into an available power 
outlet. The camera  will immediately 
power on as indicated by the power 
status button on the front.