Veo 802.11b 사용자 설명서
Page 9 of 69
Camera Setup
Observer (Ethernet) Network Camera
Before installing the Veo Observer Camera, you should have an available Ethernet
LAN connection (RJ-45 port). To view the camera’s image or make any manual
configuration changes, you will need a Windows PC with Internet Explorer 5.0 or
higher, also connected to the LAN.
LAN connection (RJ-45 port). To view the camera’s image or make any manual
configuration changes, you will need a Windows PC with Internet Explorer 5.0 or
higher, also connected to the LAN.
2.1 Hardware Setup (Observer)
Connecting the Ethernet cable
Connecting the power adapter
Chapter
2
CAUTION: Make sure to only use the power
adapter supplied with your Veo Observer
Network Camera. Using a non-approved power
adapter may damage the camera.
Step 1. Plug the included Ethernet cable into the RJ-
45 connector at the back of the camera as shown.
45 connector at the back of the camera as shown.
Step 2. Plug the other end of the Ethernet cable into
any available LAN port. A typical home
router/gateway connection is shown on the left.
any available LAN port. A typical home
router/gateway connection is shown on the left.
Step 3. Connect the power supply to the back of
the camera as shown, and then plug the supply
into an available power outlet.
the camera as shown, and then plug the supply
into an available power outlet.