Canon ip3300 사용자 설명서

Routine Maintenance

Clean the Print Head if lines are missing or if white streaks appear in the printed nozzle check 
pattern. Cleaning unclogs the nozzles and restores the print head condition. Note that cleaning the 
Print Head causes used ink to be absorbed in the ink absorber. Cleaning the Print Head consumes 
ink, so perform Print Head Cleaning only when necessary.

If you click Cleaning on the Pattern Check dialog box that is displayed after printing the nozzle 
check pattern, the Print Head Cleaning dialog box shown in of step 4-(3) in the following procedure 
will appear.

Make sure that the printer is on.

Open the Front Feeder and extend the Output Paper Support.

Open the printer properties dialog box.

 Start Print Head Cleaning.

(1) Click the Maintenance tab.
(2) Click Cleaning.
(3) Select the ink group to be cleaned.

(4) Click Execute.

Print Head Cleaning starts when the POWER 
lamp starts flashing green.
Do not perform any other operations until Print Head Cleaning finishes. This takes about 
50 seconds.

(5) Load a sheet of A4 or Letter-sized plain paper in the Auto Sheet Feeder and set the 

Paper Thickness Lever to the left.

(6) Click Print Check Pattern.

The nozzle check pattern is printed.
Do not perform any other operations until the nozzle check pattern finishes printing.

Cleaning the Print Head Without a Computer
z

The Print Head can also be cleaned from the printer itself, using the RESUME/CANCEL button. 

1. Make sure that the printer is on.
2. Hold down the RESUME/CANCEL button until the POWER lamp flashes green once, and 

then release it immediately.

Clicking Initial Check Items displays the items to 

be checked before cleaning.

The nozzle check pattern will not be printed correctly if there is not enough ink. Replace the ink 

tank if the remaining amount of ink is insufficient. See “Replacing an Ink Tank” on page 22.

(3)

(4)