Panasonic AG-HVX200AP 사용자 설명서

The sound track to be recorded when shooting 
can be changed by CH1 SELECT switch and CH2 
SELECT switch.
The sound track to be recorded when dubbing 
can be changed at A. DUB INPUT item on the AV 
IN/OUT SETUP screen. (Page 112)

Adjusting the audio input level
Use the AUDIO control to adjust the recording level 
of audio signals input from the built-in microphone 
or INPUT 1/2 terminal.
•  You cannot adjust the audio signals input into the 

AUDIO IN/OUT CH1/CH2 terminals.

Listening to sound that has been dubbed
Switch between the sound that has been dubbed 
and the sound heard during shooting in the 
setup menus, PLAYBACK FUNCTIONS screen, 
32K(12bit) AUDIO. (Page 110)
ST1:
  The sound recorded during shooting is played 

back.

ST2:
  The sound that has been dubbed is played back. 
MIX:
  Both the sound recorded during shooting and 

that you have dubbed are played back.

Performing audio dubbing as you listen
You can monitor the sound by setting “ST2”.
If you use headphones when performing audio 
dubbing on a recording using microphone input, 
you can listen to the sound being dubbed.
When you perform audio dubbing using line input 
(from the audio component connected to the 
AUDIO IN/OUT jack), you can listen to the sound 
being dubbed through the speakers.

Using the memory stop mode to edit dubbed 
sound
(1) First reset the counter memory display in the 

memory stop mode at the position where the 
audio dubbing is to end. (Page 59)

(2) Rewind the tape to the position where the audio 

dubbing is to start, and start the dubbing.

(3) The tape then stops automatically at the 

position where the counter memory display was 
reset.

Built-in microphone L 

channel

CH1

CH3

Built-in microphone R 

channel

CH2

CH4

INPUT 1 (XLR)

CH1

CH3

INPUT 2 (XLR)

CH2 (CH1) CH4 (CH3)

AUDIO IN/OUT CH1 

(Pin jack)

—

CH3

AUDIO IN/OUT CH2 

(Pin jack)

—

CH4