Uniden 7000A 사용자 설명서
34
REMOTE OPERA
TION
CHANGING THE REMOTE OPERATION SECURITY CODE
The remote operation security code is preset to 798, but you can
change it by following these steps.
The remote operation security code is preset to 798, but you can
change it by following these steps.
1. Hold down
code set
until the DTAM beeps once.
appears.
2. Press
again.
(security code) and the digits of the
current code appear in sequence, then the first digit reappears.
For example, when the security code is 798, the display shows
For example, when the security code is 798, the display shows
(security code)
,
,
, then
reappears.
3. Repeatedly press
or
to set the first digit, then
press
. The second digit appears.
4. Press
or
to set the second digit, then press
The third digit appears.
5. Press
or
to set the third digit, then press
The DTAM sounds a long beep and announces the
security code.
security code.
REMOTE OPERATION
NOTE:
Be sure to set each digit within 8 seconds. Otherwise, you must start
over from Step 1.
over from Step 1.