Lorex Technology LH130 사용자 설명서

10

Basic Setup

Test the cameras before permanent installation. Plan where you will route the wiring for 
the camera and where you will aim the camera.

• Mount the camera where the lens is away from direct and intense sunlight. 
• Plan your cable wiring so that it does not interfere with power lines or telephone lines.
• Ensure that the camera wiring is not exposed or easily cut.
• Mount the camera in an area that is visible, but out of reach.
• Avoid pointing the camera at a glass window to see outside, as this may result in a poor image 

caused by glare from indoor / outdoor lighting conditions. 

• Adjust the camera angle so that it covers an area with high traffic.
• In "high-risk" locations, have multiple cameras point in the same area. This provides camera 

redundancy if a vandal attempts to damage the camera.

Mount the camera(s) to the desired mounting surface according to the instructions that came 
with the camera(s). Choose a firm mounting surface.

NOTE: If you wish to mount cameras to drywall, it is recommended to use drywall plugs (not 

included).

Adjust the camera stand to ensure that the camera has a satisfactory view of the area you 
would like to monitor. Stand configuration depends on the mounting surface you have chosen 
(see below for suggested stand configurations).

NOTE: There are two connection points for certain cameras. Secure the stand to the top thread 

for wall mounts or ceiling mounts. Secure the stand to the bottom thread for table 
mounts or wall mounts.

: Cameras differ in terms of installation or mounting instructions. Please see 

the documentation that came with your camera(s) for specific installation instructions.

Table Mount

Wall Mount

Ceiling Mount

Camera model not be exactly as shown.

Top thread
(Ceiling mount, Wall mount)

Bottom thread
(Table mount)

Secure to camera 
thread

Camera model may not be exactly as shown.