Vermont Casting 1610CE 사용자 설명서

12

Cast iron stoves are heavy, and it will take two to four 
people to move your Defiant into position.
Wipe the protective coating of oil from the griddle with a 
clean dry rag or a paper towel.  
Install the handle on the griddle. Slip the bolt through a 
washer, a nylon bushing, then through the handle and 
the other bushing, then through the steel spacer and 
into the griddle tab. (Fig. 17) Tighten securely.

The stove is shipped with the legs attached. In some 
instances, the legs may have been removed. Fol-
low these instructions to reattach the legs. Install the 
stove legs (Fig. 21) using the hex head bolts from the 
parts bag. Use 3/8” washers with all four legs; the door 
handle holder installs on the right front leg. Position the 
holder so the hole to accept the handle hub faces out 
from the right side of the stove. Tighten the bolts firmly. 
CAUTION: Overtightening can strip tapped threads.
NOTE: When moving the stove, lift the stove to take 
weight off the legs whenever possible. Dragging or 
sliding the stove, especially across rough surfaces can 
cause the legs to loosen or even break.

�����
�����������
�����

Leg Bolt and 

Washer

ST858

Fig. 18  Attach the stove legs.

ST564
handle holder
12/13/00

Bottom Heat Shield

Door Handle Holder

Leg Bolt and Washer

ST564

Fig. 19  Handle holder and heat shield positions.

ST536

Fig. 17  Attach the griddle handle.

ST536

Attach 

griddle handle

11/00

Bushings

Spacer

Knob

Washer

Bolt

Use the removable handle to open or close the doors. 
After using it, remove the handle so it will not get hot. 
Store the handle in the handle holder installed behind 
the right front leg. (Fig. 19)

NOTE: The Bottom Heat Shield is required in most 
installations. Refer to Floor Protection, Page 10, for 
further details.
1.  Loosen the four 10-24 x 1/2” hex head bolts from the 

corners of the ash drop on the stove bottom.  

3.  Align the bottom heat shield holes with the four 

bolts. The outside air cutout hole should be toward 
the rear of the stove.

4.  Tighten the four hex head bolts securely after pass-

ing all four bolts through the large end of the key-
holes and then pulling the shield forward to engage 
the smaller ends of the keyhole slots. (Fig. 20)

�����
������������������
�����

ST857

Fig. 20  Attach the optional bottom heat shield.

Bottom Heat Shield

5.  Attach the right side of the heat shield to the handle 

holder using a #10 1/2” phillips sheet metal screw.