KitchenAid W10117506B 사용자 설명서

INSTALLATION INSTRUCTIONS

Outdoor Sear Burner Installation

■

Unpack sear burner. Remove all packaging materials and
remove sear burner from carton.

■

Move sear burner close to desired outdoor location.

Make Gas Connection

Natural Gas Use

This installation must conform with local codes and ordinances.
In the absence of local codes, installations must conform with
either the National Fuel Gas Code ANSI Z223.1 - latest edition, or
CAN/CGA-B149.1 Natural Gas and Propane installation code.

1. Place sear burner into outdoor enclosure, but leave enough

room in back to connect to gas supply and plug in electrical
single-prong plug to sear burner.

2. A combination of pipe fittings must be used to connect the

sear burner to the existing gas line. If local codes permit, use
an outdoor flexible stainless steel tubing gas connector,
design-certified by CSA International, to connect the sear
burner to the rigid gas supply line. A

⁵⁄₈" diameter line is

recommended. Pipe-joint compounds suitable for use with
Natural gas must be used. Do not use TEFLON

®†

tape.

3. Using a wrench to tighten, connect the gas supply to the sear

burner. Use pipe-joint compound on all non-flared male
threads. Do not kink or damage the flexible connector when
moving the sear burner.

4. Open the manual shutoff valve in the gas supply line. The

valve is open when the handle is parallel to the gas pipe.

5. Test all connections by brushing on an approved

noncorrosive leak-detection solution. Bubbles will show a
leak. Correct any leak found.

Plug in Sear Burner

1. This built-in outdoor sear burner comes with a 5,000 mAmp

power transformer plug assembly for the igniter system. Plug
in the single-prong plug in the receptacle on the lower left-
hand side of the sear burner.

WARNING

Excessive Weight Hazard

Use two or more people to move and install
built-in sear burner.

Failure to do so can result in back or other injury.

WARNING

Explosion Hazard

Use a new CSA International approved “outdoor”
gas supply line.

Securely tighten all gas connections.

Failure to do so can result in death, explosion, or fire.

†®TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company.

A. ½" (1,3 cm) sear burner gas pipe
B. New CSA International approved

“outdoor” flexible gas supply line

C. Rear of sear burner
D. To Natural gas supply

A. Closed valve
B. Open valve

A. Single-prong plug