KitchenAid W10117506B 사용자 설명서

2. Plug into a grounded 3 prong outlet.

3. Gently slide sear burner completely into outdoor enclosure.

1. Lift off cover and grate and set aside.

2. Remove packing from around burners.

3. Reinstall grate.

The burners are tested and factory-set for most efficient 
operation. However, variations in gas supply and other conditions 
may make minor adjustments to low flame setting necessary. It is 
recommended that adjustments be made by a qualified person.

Checking and adjusting the burner flames requires removing the 
grate.

If flame goes out on the LO setting, the low flame setting must be 
adjusted.

1. Light the burner and turn control knob to its lowest setting 

and remove knob.

2. Hold the valve stem with pliers and insert a thin flat blade 

screwdriver into the shaft.

3. Watch the flame and slowly turn screwdriver 

counterclockwise.

4. Adjust flame to the minimum stable flame.

5. Replace control knob and turn off the burner.

6. Reassemble grate.

1. Remove the outdoor sear burner cover.

2. Make sure control knobs are turned to OFF.

3. Turn the gas supply on:

■

Using gas supply source other than 20 lb LP gas fuel tank:

Turn the shutoff valve to open position from the front of gas 
supply line.

See the “Gas Supply Requirements” section.

■

Using a 20 lb LP gas fuel tank:

Slowly open the tank valve.

NOTE: If flow limiting device activates, your grill may not 
light. If your grill does light, the flames will be low and will not 
heat properly. Turn tank valve and all control knobs off and 
wait 30 seconds. After shutting off the tank, very slowly open 
tank valve and wait 5 seconds before lighting.

B

A

A

B

C