Genie 1000 사용자 설명서

9

©2011 The Genie Company

 

 

9/2011

TO ENGAGE, PULL

DOWN AND TOWARD

POWERHEAD. CHECK THE 

RED BLOCK IS IN THE UP 

POSITION. THEN LET GO. 

TO DISENGAGE, PULL

DOWN AND TOWARD 

DOOR. CHECK RED 

BLOCK IN THE DOWN 

POSITION. THEN LET GO.

DOOR

DOOR

 

 

s   When replacing light cover, make sure wires are 

not pinched or near moving parts.

s   Use extreme caution when working from a ladder 

or step stool.

 

1.  Disconnect power to door opener.

s

 

– Do NOT use light bulbs with greater than 

100 Watt rating.

s

2.  Reconnect power to door opener.

s

Performing all ten (10) Limits/Force setting steps 
(page 5) erases previous Limits/Force settings.

 

 

s   Observe all safety warning and precautions!

s   Disconnect power from opener and disconnect 

carriage in rail from bullet before beginning this 
task. 

Visually inspect the chain or belt every 6 months.  
NOTE: Tension adjustments should be made with the 
door in the down position and the carriage released. 

s  At the center of the rail the chain or belt should 

not be resting on the rail.  See adjustment 
illustration on right.
– With the bullet NOT engaged to the carriage, 

tighten adjustment nut until chain/belt does 
not, at the center of the rail, rest on rail.  Do NOT 
overtighten.

s  Is there rust on chain or frayed edges on belt?

– Contact a trained door system technician for 

chain/belt replacement.

s  Are there kinks or twists in the chain or belt?  

– Contact a trained door system technician for 

chain/belt replacement.

Tighten nut to increase 
tension on chain or belt

Chain

Chain

Chain at center of rail

Approx. 1/8"

Adjustment required

Correctly adjusted

Belt

Belt

Belt at center of rail 

Approx. 1/8"

Adjustment required

Correctly adjusted

Replace remote battery with a  
CR 2032 coin cell battery.
1.  Open the remote case

using a washer or coin 

that fits into the slot at 
the top of the remote

2. Replace battery.
3.  Align components and 

snap case closed.