Genie 1000 사용자 설명서

©2011 The Genie Company

9/2011

10

Force settings are pre-programmed at the factory and 
"learned" during the Open/Close Limit settings steps. 

For normal use, these settings should not need adjustment 
with this unit. 

However, conditions possibly requiring adjustment are:

Doors with very stiff weather seals.
Doors that start down, STOP and reverse before closing. 
Doors that start up, but STOP before they completely open.

 

 

Door closing force is FACTORY set and requires no  
adjustment for normal operation.

s

including an unbalanced door, binding door track or 
broken spring. 

s

LED indicator colors                                       

 OFF

 Blue

 Purple

 Red

1.

2.

3.

Speed settings are pre-programmed at the factory for the 
maximum speed. Speed settings should not need adjustment 
with this unit. 
However, travel speed for the opener can be adjusted to a 
slower speed in both the open and close directions, To 
mimimize wear on heavier sectional doors.
NOTE: One-piece doors are automatically set to the slowest 
speed during Limits programming and cannot be adjusted.

There are 3 speed settings available for sectional doors. 
Please note that speed may be affected by door weight and 
balance, along with condition of door components and tracks. 

TEST. See page 7. 

 

 

Press & hold 
both up and 
down buttons 
2 seconds or until round 
LED turns Red. 

Press & 
Release.

Press either 
until you reach 
desired setting.

FORCE SETTINGS DONE

PROGRAM

SET

 

Press & 
Release.

PROGRAM

SET

 

USE CHART BELOW.

Press either
until you 
reach the
desired setting.

USE CHART BELOW.

LOCKS IN SETTING.

LOCKS IN SETTING.

OFF

OFF

LED indicator colors                                       

 OFF

 Blue

 Purple

 Red

High

Medium

Low

 

 

 

 

 

 

 

ACTION    

                             LED INDICATION/RESULT

Then the Current UP FORCE 
SETTING will display. SEE CHART.

Then the Current 
DOWN FORCE 
SETTING will display. 

Both LEDs TURN 
BLUE then OFF 
confirms Force 
Settings are reset. 

Both LEDs FLASH 
BLUE to confirm setting. 

 

Press & 
Release.

Press twice.

FORCE SETTINGS DONE

PROGRAM

SET

 

Press & Hold for 
about 10 seconds
or until both LEDs 
turn  

Blue. 

Then release.

PROGRAM

SET

 

Press & 
Release.

PROGRAM

SET

 

Press & 
Release.

PROGRAM

SET

 

Press either until 
you reach the
desired setting.

LOCKS IN OPENING SETTING.

LOCKS IN CLOSING SETTING.

OFF

ACTION    

                             LED INDICATION/RESULT

Then the Current Speed setting 
for OPENING travel will display. 
SEE CHART BELOW.

Then the Current Speed setting 
for CLOSING travel will display. 
SEE CHART BELOW.

NOTE: Depending on the criteria 
mentioned above, you may not 
have the option to increase speed.

Press either until 
you reach the
desired setting.

NOTE: Depending on the criteria 
mentioned above, you may not 
have the option to increase speed.

BLUE

OFF

RED

OFF

BLUE

OFF

FLASHES BLUE 3 TIMES

BLUE

BLUE

BLUE

FLASH BLUE

FLASH BLUE

BLUE

BLUE

BLUE

BLUE

FLASHES
BLUE 3 TIMES

OFF

BLUE

 

 

 

Off

Off

Off

Off

 

 

 

 

 

 

 

 

Off

 

 

 

 

 

 

 

Off