Vermont Casting 2080 사용자 설명서

8

• 

Mark and drill two 5/16”, (8mm) holes 1⁵⁄₈” 
(41mm) from the lower edge of the pipe. Locate 
the holes on an axis that will be perpendicular to 
the fireplace opening when the pipe is installed. 
(Fig. 6)

• 

Install the threaded rod (A), into the starter pipe 
using washers and hex nuts (B,C),on the outside 
of the pipe. Tighten the nuts, but do not distort the 
pipe opening. (Fig. 6)

• 

Secure the starter pipe to the chimney connector. 
(Fig. 7)

4.  Install the Floor Protector. Make sure the floor pro-

tector satisfies the requirements discussed on Page 
6.

5.  Install the Optional Outside Air Adapter. Follow 

the instructions provided with the kit.

6.  Install the Optional Surround Kit. Follow the in-

structions provided with the kit.

7.  Slide the Firebox into Position. At least two people 

will be needed to move the firebox. Position the 
firebox so the flue collar lines up with the connector. 
Use the leveling screws at the front of the Insert to 
adjust the level.  Route the power cord to the side 
nearest the power supply and test the fans. 

1���"

(35mm)

FP1097
WWsi
starter pipe
4/3/01   djt

FP1097

Fireplace 
Front

Fig. 8  Install the threaded rod inside the Starter Pipe (not a 
supplied item, starter pipe is available from the Chimney Con-
nector manufacturer).

• 

Assemble the draw-down hook and bar (D,E,F).

• 

From inside the firebox, reach up through the flue 
collar and engage the hook over the threaded 
rod inside the starter pipe. Position the steel bar 
behind the two tabs within the flue collar and then 
turn the wing nut clockwise to draw the starter 
pipe down. (Fig. 7)

This completes installation of your WinterWarm Small 
Insert. 

FP1098

pipes to cabinet

4/01

Seat the Starter 

Pipe on the two 

tabs inside the flue 

collar

Starter Pipe

Draw-down 

Bar Assem-

bly

FP1098

Fig. 7  Attach starter pipe to flue collar.