Procom ML200HBA 사용자 설명서

         WARNING:   Maintain  the
minimum  clearances  shown
i n     F i g u r e   4 .     I f     y o u   c a n ,
provide   greater   clearances   from
floor,   ceiling,  and   joining  wall.

      IMPORTANT:   Vent-free
heaters  add  moisture  to   the
air.  Although  this  is  beneficial,
installing  heater  in  rooms
without  enough  ventilation  air
may   cause  mildew  to    form
from  too  much  moisture.  See
Fresh  Air  for Combustion and
Ventilation,  pages  4 and 5.

INSTALLING THERMOSTAT
SENSING BULB
For T-Stat  Models  Only
1. Pull out the sensing  bulb  from the
    two  clips  located  in  the  shippng
    position according to the direction
   as shown by the arrow. There is no
    need to take out  the two bulb clips.
2. Take  out  the  bulb  clip  from  the
     hardware package and insert  it into
      the square hole and then insert the
     sensing bulb into the bulb clip (see
     Figure 5).

FASTENING  HEATER  TO  WALL
Mounting  Bracket
The  mounting  bracket  is  located
on   back  panel  of  heater (see
Figure 6).  It  has  been  taped  there
for shipping. Remove mounting
bracket  from  back  panel.

Removing Lower Front Panel Of
Heater
1.  Remove  two  screws  near bottom
     corners  of  lower front  panel.
2.  Pull   bottom  of   lower  front  panel
     forward, then down (see  Figure 7).

Methods  For Attaching   Mounting
Bracket  To  Wall
Only  use  last  hole  on  each  end
of   mounting   bracket   to   attach
bracket  to  wall. These  two  holes
are 16  inches  apart  from center.
Attach  mounting  bracket  to  wall
only in one of  two ways:
1.    Attaching  to  wall  stud
2.    Attaching  to  wall  anchor

Attaching  to  Wall  Anchor: This
method  allows  you  to attach
mounting  bracket  to  hollow  walls
(wall areas between  studs) or to
solid   walls  (concrete  or  masonry).

2.  Mark  screw  locations  on
wall. (see  Figure  8)
Note:  Only  mark  last  hole  on
each  end  of  mounting  bracket.
Insert  mounting  screws  through
these  holes  only.
3.   Remove  tape and  mounting
bracket  from  wall.

            WARNING:       Maintain
minimum   clearances  shown  in
Figure  8.   If   you   can,   provide
greater   clearances   from   floor
and   joining   wall.

Attaching  to  Wall  Stud:  This  method
provides  the  strongest       hold.   Insert
mounting   screws through  mounting
bracket  and into  wall  studs.

Decide   which    method  better   suits
your needs. Either method will  provide
a    secure   hold    for    the   mounting
bracket.

Marking  Screw  Locations
1.  Tape  mounting  bracket  to  wall
where  heater  will  be  located.
Make  sure  mounting  bracket  is
level.

Model ML300HBA ML300TBA

Model ML200HBA ML200TBA

5 8