Friedrich YM18 사용자 설명서

5

*  A Friedrich RC1 wireless remote control can be used to operate all 

QuietMaster

®

 Programmable models.

To start unit

1   POWER - Press the Power button once. The unit will automatically 

turn on in the mode and fan speed it was last left on.

To set mode of operation

2   COOL - Press the Cool  button to automatically switch the operating 

mode to COOL.

3   FAN ONLY - Press the Fan Only  button if you want to run the fan only. 

You may want to use this feature in conjunction with the Fresh Air/ 
Exhaust if you want to bring outside air into the room, or exhaust stale 
air. (The FRESH AIR / EXHAUST feature is located on the front of the 
air conditioner near the top. See Figure 9 on page 7.)

4   MoneySaver

  - Press the MoneySaver

  button to activate the 

MoneySaver

®

 feature. This cycles the fan with the compressor so 

that the fan does not run all the time.

To adjust temperature

5  COOLER - Press the     Cooler  button to raise the temperature 

setting.

6  WARMER - Press the     Warmer  button to lower the temperature 

setting.

To adjust fan speed

7   FAN SPEED - Press the Fan Speed button to see the current set-

ting. Press again to change the fan speed. F1 is the lowest setting 
(SLEEP SETTING), F2 is low speed (LOW), F3 is medium (MED), 
and F4 is high (HIGH).

To set the hour clock

8   SET HOUR CLOCK - Press Set Hour once to see the current clock set-

ting. Continue pressing the button until you arrive at the current time.

 

MAKE SURE YOU SET THE A.M. AND P.M. PROPERLY. (NOTE: 
MINUTES ARE NOT SHOWN ON THE DISPLAY.) A light will appear in 
the upper left corner of the display when the hour is P.M.

How to use the remote control

*

 

(QuietMaster Programmable)

To set the timer

NOTE: Set the hour clock before attempting to set timer functions. You 
can set the timer On/Off a minimum of one hour apart, and a maximum 
of 23 hours apart.

9   TIMER START - Press Start to view the current start time for cool-

ing. Continue pressing the Start button until you arrive at the start 
time you desire. The start time for cooling will then be set.

10   TIMER STOP - Press the Stop button. Continue pressing the Stop 

button until you arrive at the stop time you desire. The stop time for 
cooling will then be set. 

11   TIMER ON/OFF - Press the On/off button once to activate (light on) 

or deactivate (light off) the timer. Once the Start and Stop times 
have been selected, they will remain in memory, and cycle daily until 
changed.

 NOTE:  If the unit is unplugged or the power is interrupted, the HOUR 

CLOCK must be reset or the Timer On/off functions will not work.

 Start

8

10

7

11

9

4

3

1

2

5

6