Regency Wraps F33 사용자 설명서

Regency

®

 F33-3 Freestanding Gas Stove

13

1)  Use the ON/OFF switch, wall switch, thermostat or remote control 

to turn off the burner.

2)  Push in the PILOT knob slightly and turn clockwise to off. Do not 

force.

3)  Turn off all electric power to the appliance if service is to be per-

formed. 

1)  Turn burner OFF using "ON/OFF" switch.

2)  Turn gas control knob so indicator points to "OFF" position and allow 

5 minutes for any gas in the combustion chamber to escape.

3)  Turn gas control knob counterclockwise so indicator points to the 

"PILOT" position. Depress the gas control knob fully. Depress the 

igniter button several times until the pilot lights. After approximately 

one minute, release the gas control knob. The pilot fl ame should 

continue to burn. If the pilot does not remain lit, repeat operation 

allowing a longer period before releasing gas control knob.

4)  When the pilot stays lit, turn the gas knob further counterclockwise 

to the "ON" position.

5)  Use the ON/OFF switch, wall switch, thermostat or remote control 

to turn on the unit.

6)  Rotate the fl ame height regulator (Hi/Lo) to adjust the fl ame height 

higher or lower.

1) The 

FIRST FIRE in your stove is part of the paint curing process. 

To ensure that the paint is properly cured, it is recommended that 

you burn your fi replace for at least four (4) hours the fi rst time you 

use it with the fan on. When fi rst operated, the unit will release an 

odour caused by the curing of the paint and the burning off of any 

oils remaining from manufacturing. Smoke detectors in the house 

may go off at this time. Open a few windows to ventilate the room 

for a couple of hours. The glass panel may require cleaning.

Note:  When the glass is cold and the appliance is lit, it may cause 

condensation and fog the glass. This condensation is normal 
and will disappear in a few minutes as the glass heats up.

2)  Read and understand these instructions before operating this 

appliance. 

3)  Check to see that all wiring is correct and enclosed to prevent 

possible shock.

4)  Check to ensure there are no gas leaks.

5)  Make sure the glass in the door frame is properly positioned. Never 

operate the appliance with the glass removed.

6)  Verify that the fl ueing is unobstructed.

7)  Verify log placement. If the pilot cannot be seen when lighting the 

unit - the logs have been incorrectly positioned.

8)  The unit should never be turned off, and on again without a mini-

mum of a 60 second wait for purging.