Regency Wraps F33 사용자 설명서

Regency

®

 F33-3 Freestanding Gas Stove

15

It is possible that you will hear some sounds from your gas appliance. 
This is perfectly normal due to the fact that there are various gauges 
and types of steel used within your appliance. Listed below are some 
examples. All are normal operating sounds and should not be con-
sidered as defects in your appliance.

Blower: 
Regency

®

 gas appliances use high tech blowers to push heated air 

farther into the room. It is not unusual for the fan to make a "whirring" 
sound when ON. This sound will increase or decrease in volume 
depending on the setting of your fan switch.

Burner Tray: 
The burner tray is positioned directly under the burner tube(s) and logs 
and is made of a different gauge material from the rest of the fi rebox 
and body. Therefore, the varying thicknesses of steel will expand and 
contract at slightly different rates which can cause "ticking" and "crack-
ing" sounds. You should also be aware that as there are temperature 
changes within the unit these sounds will likely re-occur. Again, this is 
normal for steel fi reboxes.

Blower Thermodisc: 
When this thermally activated switch turns ON it will create a small 
"clicking" sound. This is the switch contacts closing and is normal.

Pilot Flame: 
While the pilot fl ame is on it can make a very slight "whisper" sound.

Gas Control Valve: 
As the gas control valve turns ON and OFF, a dull clicking sound may 
be audible, this is normal operation of a gas regulator or valve.

Unit Body/Firebox: 
Different types and thicknesses of steel will expand and contract at 
different rates resulting in some "cracking" and "ticking" sounds will 
be heard throughout the cycling process.

1)  Always turn off the gas valve before cleaning. For relighting, refer 

to lighting instructions. Keep the burner and control compartment 
clean by brushing and vacuuming at least once a year.

 

When cleaning the logs, use a soft clean brush as the logs are 
fragile and easily damaged.

2)  Clean appliance and door with a damp cloth (never when unit is 

hot).  Never use an abrasive cleaner. The glass should be cleaned 
with a gas fi replace glass cleaner (when it starts to cloud up). 

3)  The heater is fi nished in a heat resistant paint and should only be 

refi nished with heat resistant paint. Regency

®

 uses Stove Brite 

Paint - Metallic Black #6309.

4)  Make a  periodic check of burner for proper position and condition. 

Visually check the fl ame of the burner periodically, making sure 
the fl ames are steady; not lifting or fl oating. If there is a problem, 
call an authorised service person. 

5)  The appliance and fl ueing system must be inspected before use, and 

at least annually, by an authorised fi eld service person, to ensure 
that the fl ow of combustion and ventilation air is not obstructed. 

 

During the annual service call, the burners should be removed 
from the burner tray and cleaned. Replace the embers and rock 
wool.

6)  Each time the appliance is lit, it may cause condensation and fog 

the glass.  This condensation is normal and will disappear in a few 
minutes as the glass heats up.

7)  Caution: Label all wires prior to disconnection when servicing con-

trols. Wiring errors can cause improper and dangerous operation.  
Verify proper operation after servicing.