Regency Wraps F33 사용자 설명서

6

Regency

®

 F33-3 Freestanding Gas Stove

1)  For easier assembly, tip the stove on its back (preferably onto a 

soft surface to prevent scratching).

  
2)  Unscrew the 4 bolts in the underside of the stove. Align the holes 

in the corners of the pedestal top with the corresponding holes in 
the base of the stove.  Use washers which are supplied with the 
pedestal as shown in diagram. Reinstall bolts.

3)  Push the Regency

®

 logo into the two holes in the front bottom left 

corner of the pedestal cover plate.

 
Note: Any paint touch up should be done prior to placing logo 

4)  See wiring instructions below.

2)  If required, adjusting the primary air to ensure that the fl ame does 

not carbon. First allow the unit to burn for 15-20 min. to stabilize.

3)  Check for proper draft.

CAUTION: Any alteration to the product that causes sooting or carboning 
that results in damage is not the responsibility of the manufacturer.

The clearances listed below are MINIMUM distances.  Measure the 

clearance to both the appliance and the chimney connector.  The 

farthest distance is correct if the two clearances do not coincide. For 

example, if the appliance is set as indicated in one of the diagrams but 

the back wall is too close, move the stove until the correct clearance 

to the connector is obtained.  

This appliance may be installed only with the clearances as shown 

in the situations pictured.  Do not combine clearances from one type 

of installation with another in order to achieve closer clearances. Use 

the minimum clearances shown in the diagrams.

A Side 

Wall 

to 

Unit   

250 mm

B Back 

Wall 

to 

Unit   

150 mm

E  Side Wall to Unit 

 

 38  mm

C  Back Wall to Flue Centerline 

292  mm

D  Side Wall to Flue Centerline 

559  mm

F  Side Wall to Flue Centerline 

330  mm