Tascam SN29401376 사용자 설명서

Here you can specify the distance from each speaker to the 
listening position so that the sound from each speaker 
arrives at the listener’s ears as the sound designer intended.

■

`

feet:

Distances can be set in feet. Range: 0.2ft to 30.0ft in 
0.2 foot steps.

`

meters:

Distances can be set in meters. Range: 0.06m to 
9.00m in 0.06 meter steps.

(The default setting varies from country to country.)

■

`

Specify the distance from each speaker to your 
listening position.

• Speakers that you set to “No” or “None” in 

“Speaker Configuration” cannot be selected (

➔ page 50).

Here you can adjust the level of each speaker with the 
built-in test tone so that the volume of each speaker is the 
same at the listening position.

• These settings cannot be calibrated in either of the following 

cases:
– The  “Audio TV Out” setting is set to “On” (

– “HDMI Control(RIHD)” is set to “On” (

➔ page 60) and 

you’re listening through your TV speakers.

– The AV receiver is muted.

■

*1

`

–12dB to 0dB to +12dB in 1 dB steps.

■

`

–15dB to 0dB to +12dB in 1 dB steps.

• Speakers that you set to “No” or “None” in 

“Speaker Configuration” cannot be selected (

➔ page 50).

*1

For the center speaker and subwoofer, the level settings made 
by using the Quick Setup are saved in this menu (

• If you’re using a handheld sound level meter, adjust the level of 

each speaker so that it reads 75 dB SPL at the listening position, 
measured with C-weighting and slow reading.

With the Audio Adjust functions and settings, you can 
adjust the sound and listening modes as you like.

■

`

Main 

`

`

This setting determines which channel of a stereo 
multiplex source is output. Use it to select audio channels 
or languages with multiplex sources, multilingual TV 
broadcasts, and so on.

■

`

Left + Right 

`

`

This setting specifies the channel to be used for playing 
any 2-channel digital source such as Dolby Digital, or 2-
channel analog/PCM source in the Mono listening mode.

This setting is set automatically by Audyssey 2EQ

®

 

Room Correction and Speaker Setup (

This setting is set automatically by Audyssey 2EQ Room 
Correction and Speaker Setup (

“Setup”