Hoover Bagless Upright Vacuum Cleaner 사용자 설명서

To obtain approved HOOVER service
and genuine HOOVER parts, locate 
the nearest

by:

• checking the Yellow Pages under 

“Vacuum Cleaners - Household” OR -

• checking the list of Factory Service 

Centers provided with this cleaner 
OR -

• checking the Service section of The 

Hoover Company on-line at 

OR -

• calling 

for an 

automated referral of authorized 
service outlet locations (U.S. only).

send your cleaner to The Hoover

Company in North Canton for service,
this will only result in delay.

If further assistance is needed, contact
The Hoover Company Consumer
Response Center, North Canton, 
Ohio 44720, Phone:  330-499-9499.

contact Hoover Canada,

Burlington, Ontario L7R 4A8, 
Phone:  1-800-263-6376.

Always identify your cleaner by the

model number when 

requesting information or ordering parts.
(The model number appears on the
bottom of the cleaner.)

This Hoover Cleaning Performance Sys-
tem is for comparing the relative pro-
gressive performance of 

and not for comparison

with any other brands. The majority of
this rating is based upon the ASTM
International Carpet Cleaning Effective-
ness Test (ASTM Test F608). Other per-
formance factors include Hose Power
(ASTM Test F558), Surface Litter Clean-
ing, Hard Floor Cleaning, Edge Clean-
ing, Cleaning Width, and Air Filtration.

When agitator brushes are worn, the
agitator should be replaced. 

To check condition of brushes, 

Move edge of a card across bottom
plate while turning agitator. To maintain
cleaning effectiveness, replace agitator
if brushes do not touch card.

Your cleaner requires either a 13” or 15”
agitator. When purchasing a new agita-
tor, ask for one of the following:

13” - 

15”

Remove bottom plate, belt and agitator
following directions in “The belt” section
beginning with Fig. 3-18.

Discard old agitator.

Continue following the directions in “The
belt” section to reposition belt, new
agitator and bottom plate.

An internal thermal protector has been
designed into your cleaner to protect it
from overheating.

If this

happens, proceed as follows:

1. Turn the cleaner OFF and discon-

nect it from the electrical outlet.

2. Check secondary and final filters for

dirt accumulation.

3. Refer to “Clearing blockages”

section. 

4. 

the

thermal protector automatically resets
and cleaning may continue.

If the thermal protector continues to
activate after following the above steps,
your cleaner may need servicing

(see“Service” section).

The motor is equipped with bearings
that contain sufficient lubrication for the
life of the motor. The addition of lubricant
could cause damage. 

The agitator brush roll is equipped with
two ball bearings that should be lubri-
cated periodically by a Hoover Factory
Service Center or an Authorized Hoover
Warranty Service Dealer (Depot).