Sony STR-DA1800ES 사용자 설명서
46
US
D:\NORM'S JOB\SONY HA\SO120031\STR-DA1800ES_PMRF
02\4428194122_USFR\US04GET_STR-DA1800ES-CEL.fm
02\4428194122_USFR\US04GET_STR-DA1800ES-CEL.fm
masterpage: Left
STR-DA1800ES
4-428-194-12(2)
4-428-194-12(2)
3
Press
V/v repeatedly to select
“Auto Cal.”, then press
or
b.
4
Press
B/b repeatedly to select
“Start”, then press
.
5
Press
to select “START”.
6
The measurement starts in five
seconds.
seconds.
The measurement process will take
approximately 30 seconds with a test
tone.
When the measurement ends, a beep
sounds and the screen switches.
approximately 30 seconds with a test
tone.
When the measurement ends, a beep
sounds and the screen switches.
Note
If an error code appears on the screen, see
“Message list after Auto Calibration
measurement” (page 48).
“Message list after Auto Calibration
measurement” (page 48).
7
Press
V/v repeatedly to select
the item you want, then press
.
Retry:
Performs the Auto Calibration again.
Save:
Save the measurement results and exits
the setting process.
the setting process.
Warning:
Displays warning related to the
measurement results. See “Message list
after Auto Calibration measurement”
(page 48).
measurement results. See “Message list
after Auto Calibration measurement”
(page 48).
Exit:
Exits the setting process without saving
the measurement results.
the measurement results.
8
Save the measurement result.
Select “Save” in step 7.
Notes
• The A.P.M. (Automatic Phase Matching)
function is activated after you save the
measurement result.
measurement result.
• The A.P.M. function does not work in the
following cases.
– The calibration type is set to “Off” when
– The calibration type is set to “Off” when
using the “Cal. Type” Auto Calibration
– When Dolby TrueHD or DTS-HD signals
with a sampling frequency of more than
48 kHz are being received.
48 kHz are being received.
9
Press
B/b repeatedly to select
“Cal. Type”, then press
.
Full Flat:
Makes the measurement of frequency
from each speaker flat.
from each speaker flat.
Engineer:
Sets to “the Sony listening room
standard” frequency characteristics.
standard” frequency characteristics.
Front Reference:
Adjusts the characteristics of all the
speakers to match the characteristics of
the front speaker.
speakers to match the characteristics of
the front speaker.