Dynaudio SUB 600 사용자 설명서
8
Dynaudio Sub 600
BEFORE OPERATION
Controls and connections
➊
POWER
Subwoofer auto power mode:
Subwoofer auto power mode:
• ON = Auto mode disabled (subwoofer is switched on permanently, when main
power switch is set to ON).
• AUTO = Auto mode enabeld (when main power switch is set to ON and a music
signal is detected, the internal amplifier is activated automatically).
➋
GAIN
Subwoofer volume level.
Subwoofer volume level.
➌
PHASE
Phase setting: phase can be set to 0° or 180°.
Phase setting: phase can be set to 0° or 180°.
➍
SAT Highpass
Allows cutting off low frequencies of the signal provided at the SAT Output:
Allows cutting off low frequencies of the signal provided at the SAT Output:
• Flat = signal is not processed
• 60 = cut-off frequency at 60 Hz
• 80 = cut-off frequency at 80 Hz
• 60 = cut-off frequency at 60 Hz
• 80 = cut-off frequency at 80 Hz
➎
SUB Lowpass
Subwoofer lowpass frequency: continuously variable from 50 to 150 Hz.
Subwoofer lowpass frequency: continuously variable from 50 to 150 Hz.
➏
SAT/SUB Input, SAT Output
• SAT/SUB Input: Input for full bandwidth signal from processor/receiver. This
signal will be processed according to the SAT Highpass setting and provided at
the SAT Output connection for satellite speakers to be connected.
the SAT Output connection for satellite speakers to be connected.
• SAT Output: Output for satellite speakers to be connected. This signal is
processed according to the SAT Highpass setting.
ON
AUTO
GAIN
POWER
PHASE
SUB Lowpass
SAT Highpass
SAT/SUB Input
SAT Output
LFE / Slave IN
OUT
Flat 60 Hz
LFE
Slave
80 Hz
Min
Max
50 Hz
150 Hz
0° 180°
LEFT
RIGHT
SUB I/O
To Slave
100-120V/220-240V
~ 50/60Hz 3.15A
FUSE T3.15A L 250V
OFF
ON
➊
➋
➌
➍
➎
➏
➐
➑
➒
➓