Panasonic SC-HT870 사용자 설명서

RQT7429

∫ Front and surround speaker height

(Assembled diagram)

≥Check the screws you tightened on page 4.

e.g. Attaching the stand to the lower rear of the speaker

∫ Preventing the speakers from falling over (Front and surround speakers)

Preparation
Attach screw eyes (not included) to secure the speakers to the wall 
(‹diagram right).

≥You will need to obtain the appropriate screw eyes to match the 

walls and pillars to which the screw eyes are going to be 
fastened.

≥Consult with a qualified housing contractor concerning the 

appropriate procedure when attaching to a concrete wall or a 
surface that may not have strong enough support. Improper 
attachment may result in damage to the wall or speakers.

1 Thread the string (not included) through the slot on the 

2 Loop the string through the screw eye and tie tightly.

For your reference
You can enjoy good acoustics by 
adjusting the height of the speaker 
with the height of the television so the 
center positions of both are 
approximately the same.

1,160 mm

750 mm

818 mm

575 mm

704 mm

Stopper
screw
Do not 
remove.

You can adjust within this range.

Stopper screw
Screw to stop mounting plate from moving or 
sliding below this point.

1 Loosen the attached speaker mounting 

2 With one hand on the base, and the other 

holding the speaker, adjust the height of 
the speaker up and down.
≥After adjusting the height, tighten the screw 

on the mounting plate securely.

_:

 Copper

`:

 

Silver

1 Twist off the vinyl ends of 

2 Press the speaker cable into the groove.

If there is any excess speaker cable, 
detach the rubber cap on the top of 
the pipe and thread the speaker 
cable into the opening while pulling 
the speaker cable from the bottom of 
the base.

Insert the wire 
fully.

1 Press the speaker 

2 Fit the speaker 

String (not included)

Screw eye (not included)

e.g.

RQT7429-2B book.book  5 ページ  ２００４年３月４日　木曜日　午前１０時３６分