TOA Electronics VM-2120 사용자 설명서

60

• Use the supplied labels to indicate the names of each input and output on the front panel. Write the name in

the label, and affix it under each input or output volume control. See p. 8 "NOMENCLATURE AND
FUNCTIONS" for the place the label is affixed to. When making the label with a word processor, etc., be
sure that its size is no larger than 24 mm x 6 mm. 

• Use the supplied 

label to indicate the set position of each volume control. 

Label type 

Name label A: For setting on the RM-200M's left side 
Name label B: For setting on the RM-200M's right side, and RM-210 

Paper: Under 0.2 mm thick 

(1) Preparation by hand 

Copy the "Pattern paper for hand writing" on the next page. After writing a name, cut out the pattern paper
aligning it with the cutting guidelines. 

(2) Preparation by using a PC or word processor 

Prepare and print according to the instructions given in the "Dimensional diagram for printing devices" on
p. 62. Then cut out to the instructed size. 

• Fully insert the name label cut out to the instructed size into the label entry slit. 

• To remove the label, pull it out of the slit using the tip of knife blade. 

Remote
microphone
RM-200M

Zone 1

Zone 2

Zone 3

Zone 4

Zone 5

Name label entry slit

Name label B
(already prepared and cut out) 

Name label A