Shindaiwa EB802RT 사용자 설명서

다운로드
페이지 60
10
24
Figure 15
Stop Button
Ignition Switch
OFF
EB802
EB802RT
Adjusting Engine Idle Speed
IMPORTANT!
A clean and unrestricted airflow is essen- 
tial to your blower’s engine performance 
and durability! Before attempting any 
carburetor adjustments, inspect and clean 
the engine air filter as described in the 
maintenance section of this manual.
Idle Increase
Idle Decrease 
Idle Adjustment 
Screw
Figure 16
Place the unit on the ground and start 
the engine, then allow it to idle 2-3 min-
utes until warm.
If a tachometer is available, the engine 
idle speed should be final adjusted to 
2,000 (±200) min
-1
 (RPM). See Figure 16.
1.
2.
NOTE:
Carburetor fuel mixture adjustments are 
preset at factory on units with emission 
control systems and cannot be serviced 
in the field.
IMPORTANT!
Blower tubes and the air cleaner must 
be in place while adjusting engine idle! 
Engine idle speed will also be affected if 
the blower tubes are blocked or incor-
rectly installed! 
Repeat the appropriate starting procedures 
for warm or cold engine. If the engine 
still will not start, follow the “Starting a 
Flooded Engine” procedure. 
Disconnect the spark plug lead, and 
remove the spark plug (see page 12 for 
procedures).
If the spark plug is fouled or is soaked 
with fuel, clean or replace the plug as 
required.
1.
2.
Cool the engine by allowing it to run at 
idle for 2–3 minutes.
Push and hold the Stop button down 
until the engine stops. 
RT Model: Slide 
the ignition switch towards the rear to 
“O” (OFF). See Figure 15.
1.
2.
With the spark plug removed, open 
the choke, put the throttle lever in the 
full throttle position, then clear excess 
fuel from the combustion chamber by 
cranking the engine several times.
Install and tighten the spark plug, and 
reconnect the spark plug lead. 
3.
4.
Repeat the starting procedures for a 
warm engine.
If the engine still fails to start or fire, 
refer to the troubleshooting flow chart 
at the end of this manual.
5.
6.
If The Engine Does Not Start
Starting A Flooded Engine
Starting the Engine (continued)
Stopping The Engine