Shindaiwa EB802RT 사용자 설명서

11

RT Throttle RT

Turbo

dB

Throttle Limiter

The RT blower has a throttle limiter func-

tion that allows the operator to pre-set the 

maximum engine speed. This is useful for 

reducing the noise emitted by the blower 

in noise sensitive areas.

Setting Throttle Limiter:

For reduced noise setting, move the 

throttle limiter located on the right side of 

the throttle control to the dB setting. See 

Figure 18.

Throttle Control RT

To bring min

-1

(RPM) down to idle, push 

lever back up into original position.

Adjusting Throttle Limiter:

Remove the plug located at the top of 

the throttle assembly. See Figure 19.
Move the throttle limiter lever to the 

“dB” setting. See Figure 19.
With the engine running and while 

depressing the throttle trigger, use a small 

Phillips screw driver to turn the adjustment 

screw clockwise to decrease min

-1

(RPM) 

and counter-clockwise to increase until 

desired limited min

-1

(RPM) is achieved. 

Reinstall limiter adjustment plug.

1.

2.

3.

4.

The RT blower is equipped with a multi- func-

tion throttle control. The “Cruise” function 

allows the operator to use a thumb controlled 

lever for constant speed use without using the 

throttle trigger. This is useful for limiting the 

fatigue caused from holding the throttle for 

extended periods of time.

Turbo

dB

T

urbo

dB

On the opposite side, a two position “Lim-

iter” control allows full engine speed when 

set for “Turbo” or limits the throttle to a 

pre-set engine speed when set to low noise 

(dB) setting. 

Using the right thumb, push the throttle lock 

lever down until the desired min

-1

(RPM) set-

ting is reached. See Figure 17.

Cruise Function

NOTE:

With the throttle limiter adjusted to 3,850 
min

-1

, the RT blower will have a sound 

level of 65 dB(A) measured at 15m (50 

feet) per ANSI B175.2.