Shindaiwa EB802RT 사용자 설명서

Remove the air cleaner cover by loosen-

ing the thumbscrews and lifting. See 

Figure 21.
Remove and inspect the pre-filter. If the 

pre-filter is torn or otherwise damaged, 

replace it with a new one.

1.

2.

IMPORTANT!

The blower uses a special high capac-

ity dry-type air filter element. The filter 

should not be cleaned with a liquid cleaner 

and must NEVER be oiled!

Clean the pre-filter with soap and water. 

Let dry before reinstalling. 
Inspect the air cleaner element. If 

the element is damaged or distorted, 

replace it with a new one.

3.

4.

13

IMPORTANT!

MAINTENANCE, REPLACEMENT 

OR REPAIR OF EMISSION CONTROL 

DEVICES AND SYSTEMS MAY BE PER-

FORMED BY ANY REPAIR ESTABLISH-

MENT OR INDIVIDUAL, HOWEVER, 

WARRANTY REPAIRS MUST BE PER-

FORMED BY A DEALER OR SERVICE 

CENTER AUTHORIZED BY SHINDAIWA 

CORPORATION THE USE OF PARTS 

THAT ARE NOT EQUIVALENT IN PER-

FORMANCE AND DURABILITY TO 

AUTHORIZED PARTS MAY IMPAIR 

THE EFFECTIVENESS OF THE EMIS-

SION CONTROL SYSTEM AND MAY 

HAVE A BEARING ON THE OUTCOME 

OF A WARRANTY CLAIM.

Maintenance

Daily Maintenance

 

WARNING!
To reduce fire hazard, keep 

the engine and muffler free of dirt, 
debris, and leaves.

 

WARNING!
Non-standard parts may 

not operate properly with your unit 
and may cause damage and lead to 
personal injury.

NOTE:

Using non-standard replacement parts 
could invalidate your Shindaiwa warranty.

Every 10 Hours

CAUTION!
Never operate the blower if the air 
cleaner assembly is damaged or 
missing!

Inspect the engine, tank, and hoses 

for possible fuel leaks, and repair as 

necessary.
Inspect the entire blower for loose, 

damaged, or missing components, and 

repair as necessary.
Carefully remove any accumulations 

of dirt or debris from the muffler and 

fuel tank. Dirt build-up in these areas 

can lead to engine overheating, fire or 

premature wear.

■

■

■

IMPORTANT!

Direct the air stream at the inside face of 

the filter only!

WARNING!
Before performing any 

maintenance, repair or cleaning work 
on the unit, make sure the engine is 
completely stopped. Disconnect the 
spark plug wire before performing 
service or maintenance work.

CAUTION!

The engine is cooled by air drawn 
into the air intake cover on the 
blower housing. The blower fan then 
pushes the cooling air through an 
opening in the fan housing, forcing it 

past the cylinder cooling fins. Failure 
to keep the cooling system and its 
passages clear of debris will likely 
result in engine overheating, a major 
cause of serious engine problems 
that can lead to failure.

Remove all dirt and debris from blower 

exterior and the engine. Check the 

cooling fins and air cleaner for clog-

ging and clean as necessary.

■