Echo PB-755S T 사용자 설명서

Parts Required:   As needed: Heat Shield

  1.  Remove spark plug lead from spark plug, and remove engine 

cover.

  2.  Place piston at top dead center. Remove muffler (A) and heat 

shield  (B). 

  3.  Use a wood or plastic scraping tool to clean deposits from cylin-

der exhaust port.

Never use a metal tool to scrape carbon from the exhaust port.  

Do not scratch the cylinder or piston when cleaning the exhaust 

port. Do not allow carbon particles to enter the cylinder. 

  4.  Inspect heat shield, and replace if damaged.

  5.  Install heat shield  and muffler.

  6.  Tighten muffler mounting bolts (or nuts) to 95-130 in•lbf  

(110-150 kgf•cm).

  7.   Install engine cover and attach spark plug lead.

  8.   Start engine, and warm to operating temperature.

  9.   Stop engine, and re-tighten mounting bolts to specifications.

New engines must be operated a minimum duration of two tanks of fuel 

break-in before carburetor adjustments can be made. During the break-

in period your engine performance will increase and exhaust emissions 

will stabilize. Idle speed can be adjusted as required.

This engine has been factory adjusted to maintain satisfactory starting, 

emission, and durability performance up to 1,100 feet above sea level 

(ASL) (96.0 kPa). To maintain proper engine operation and emission 

compliance above 1,100 feet ASL the carburetor may need to be ad-

justed by an authorized ECHO service dealer.

If the engine is adjusted for operation above 1,100 feet ASL, the 

carburetor must be re-adjusted when operating the engine below 

1,100 feet ASL, otherwise severe engine damage may result.