Husqvarna 210 C 사용자 설명서

 

English - 17

 

1.

If the lawn in the proposed working area is taller 
than 10 cm, mow it using a normal lawn mower. 
Then collect the clippings.

2.

Read carefully through all the steps before the 
installation.

3.

Check that all parts for the installation are 
included:

The numbers in brackets refer to the detail 
diagram 

 

 on 

page 11.

• Operator’s Manual (23)

• Automower

• Loop generator/charger (18)

• Loop wire for the boundary wire (15)

• Staples (19)

• Connector for the loop wire (20)

• Measurement gauge (20)

• Solderless coupler for the loop wire (22)

During installation you will also need: A hammer to 
knock the staples into the ground, combination pliers, 
and a straight spade if the boundary wire is to be 
buried.

 

The loop generator/charger must be placed where it 
is well ventilated and is not exposed to direct sunlight. 
The mower's battery is spared if it is charged in the 
lowest possible ambient temperature. It is also 
beneficial if the transformer can be placed under a 
roof.

Consider the distance to a wall socket when choosing 
the position. The loop generator/charger must be 
connected to a 230 V wall socket and there must be 
room for the mower when it is to charged.

It is recommended to use an earth fault-breaker when 
connecting the transformer to the wall socket.

3012-756

3012-757

3012-752