Husqvarna 210 C 사용자 설명서
English - 23
3. INSTALLATION
Automower can mow areas inside
the working area that slope up to
35 cm per distance metre (35 %).
Areas that slope more must be
demarcated by the boundary wire.
the working area that slope up to
35 cm per distance metre (35 %).
Areas that slope more must be
demarcated by the boundary wire.
When any part of the working area's
boundary slopes more than 10 cm
per distance metre (10 %), the
boundary wire must be routed about
35 cm in on flat ground before the
slope starts.
boundary slopes more than 10 cm
per distance metre (10 %), the
boundary wire must be routed about
35 cm in on flat ground before the
slope starts.
Laying out the boundary wire
Run the boundary wire around the working area, but
wait before connecting the wire to the loop
generator/charger.
wait before connecting the wire to the loop
generator/charger.
Tip!
Use the supplied measurement gauge as a
guide when you lay out the boundary wire. This helps
you to easily set the correct distance between the
boundary wire and the boundary/obstacle.
you to easily set the correct distance between the
boundary wire and the boundary/obstacle.
If you intend to staple down the boundary wire:
•
Tip!
Mow the lawn where the wire is to be laid
using a normal lawn mower or a trimmer. It will
then be easier to lay the wire close to the ground
and the risk of the mower cutting the wire off is
reduced.
then be easier to lay the wire close to the ground
and the risk of the mower cutting the wire off is
reduced.
IMPORTANT INFORMATION
Extra wire must not be placed in coils outside
the boundary wire. This can disrupt
Automower™.
the boundary wire. This can disrupt
Automower™.
3012-769
3012-221
3012-281