Yard Machines 570 사용자 설명서

6

This owner’s guide is an important part of your new Yard-Machine lawn mower. It will help you to
assemble, prepare and maintain your mower. Please read and understand what it says. 
Before you start assembling the mower for its first use, please locate its model plate and copy the
information on to this owner’s guide. The information on the model plate is very important if you need
help from your nearest service center or the Yard-Machine customer support department. 

• Every mower has a model plate. You can locate it by standing behind the unit in the operating

position and looking down at the cutting deck. 

• The model plate will look like Figure 1.

FIGURE 1  

•

Remove staples, break glue on top flaps, or cut tape at carton end and peel along top flap to open 
carton.

•

Remove loose parts included with the unit. A list of loose parts is given below. It is recommended that 
you compare this list with the loose parts included in the carton and identify each part before starting to 
assemble the unit. 

•

Cut along dotted lines and lay carton down flat. Remove packing material.

•

Roll or slide unit out of carton. Check carton thoroughly for loose parts. Make sure that no part is 
missing.

NOTE: Make sure not to crimp the cables while removing the loose parts or the entire unit from the carton.

NOTE: Reference to right or left hand side of the mower and/or front or behind the mower is observed from 

the operating position.

1.

Upper handle

2.

Lower handle

3.

Hardware pack (See following page for an illustrated list of the hardware pack.)

4.

Rear hi-wheel

5.

Front wheel

NOTE: Remember that all hardware necessary for assembling the mower is contained in the
hardware pack, and is identified in the following section.

XXX-X-XXX-X-XXX XXXXXXXXXXX

This is where mower model number will be.

This is where mower serial number will be.

Copy the model number here:

Copy the serial number here: