Yard Machines 570 사용자 설명서

8

• Pair of Pliers 
• Funnel 
• Set of adjustable wrenches

• Before setting up your lawn mower, disconnect the spark plug wire from the spark plug, and

ground it against the engine. If the engine is equipped with the optional rubber boot, attach the
boot to a bolt on the engine to ground. See Figure 2.

FIGURE 2  

• Raise the rear of the mower deck and block securely. 
• Place the lower handle (pointed side down as shown in Figure 3) over the deck on one side and

align the holes on the deck with those on the handle. See Figure 3.

• Holding the lower handle in position with one hand, place the handle bracket next to the lower

handle, aligning the holes on the bracket with those on the handle as well as the deck.

• Insert two hex bolts through the handle bracket, and secure with two flange lock nuts on inside of

the  deck. See Figure 3.    

• Insert third hex bolt through the remaining hole at lower end of handle bracket and the middle hole

on the deck. See Figure 7 inset for details. Secure with flat washer between bracket and deck, and
a bell washer and hex nut from inside the deck. See Figure 3. Keep this finger-tight now.

• Secure the upper end of the handle bracket to the lower handle with a self-tapping screw included

in the hardware pack. See Figure 3. 

• Tighten the self-tapping screw securely. Tighten the bolt at the other end of the handle bracket that

was left finger tight earlier.  

• Attach the lower handle on the other side of the deck in the same way.  

FIGURE 3  

Spark Plug Wire

Rubber Boot 

Attach bracket

& handle here

Attach 
to deck

self-tapping 
screw here

Insert

Place lower
handle this 
way