Roland MC-909 사용자 설명서
122
Sample Edit
Amp
This operation applies an envelope (time-variant change) to the
volume of the sample.
volume of the sample.
1.
Press [NORMALIZE/AMP] and then press [F3 (Amp)].
Alternatively, hold down [SHIFT] and press [F6 (Amp)]).
2.
Press [F1 (Sample List)] and select a sample.
3.
Use [CURSOR (up/down)] to select a parameter.
4.
Use [VALUE] or [INC/DEC] to set the value.
5.
If you want the edited sample to replace the current
sample, press [F4 (Over Write)] to display the “
✔
”
mark.
6.
Press [F6 (Execute)].
A message will ask you for confirmation.
7.
To execute, press [F6 (Execute)].
*
To cancel, press [F5 (Cancel)].
Current Point
Currently selected point
Beginning near the start point, the points
will be numbered 1, 2, 3, or 4.
will be numbered 1, 2, 3, or 4.
Point 1–4
Location of the current point
Rate 1–4
Amplification ratio of the current point
Specifies how the volume of each point is
to be boosted relative to the current value.
to be boosted relative to the current value.
Range:
0–400%
MC-909_Ref_e.book 122 ページ ２００５年３月１日 火曜日 午後３時２９分