Roland MC-909 사용자 설명서

 

Menu

 

Here you can make settings for the panel controllers and the screen.

 

Here you can specify how the sequencer will operate, and make MIDI-related settings.

 

Pad Velocity

REAL, 1–127

Strength of the note when you press a velocity pad
If you set this to REAL, you can vary the dynamics of the sound by varying the strength with 
which you press the pad.

 

TTE Slider Type

TTE, PITCH BEND, 
MODULATION

Function of the turntable emulation slider

 

 Standard turntable emulation

 

 Pitch bender

 

 Modulation

TTE Magnify

-1– +1 – -200– +200

Variable range of the turntable emulation slider

Tap Switch

OFF, ON

Tap button on/off

Tap Resolution

QUARTER, 8TH, 
16TH

Tap tempo resolution
The resolution (note value) to be used when using [TAP] to change the tempo

 

 Quarter note

 

 Eighth note

 

 Sixteenth note

D Beam ID

0–3

When using two or more MC-909 units together, you can specify a different ID for each unit 
so that the D Beam controllers of the units will not interfere with each other.

D Beam Sens L

0–127

Sensitivity of the D Beam controllers

The sensitivity of the D Beam controller will change depending on the amount of light in 
the vicinity of the unit. If it does not function as you expect, adjust the sensitivity as appro-
priate for the brightness of your location. Increasing this value will raise the sensitivity.

D Beam Sens R

 

Screen Saver Type

1–10

Type of screen saver

Screen Saver Time

OFF, 5–60 min

Time (minutes) until the screen saver begins working

If this is OFF, the screen saver will not appear.

 

Back Ground Picture

1–10

File that is to be displayed as the screen background

Press [F5 (Import BMP)], and load a bitmap file from the TMP/BMP folder within USER/
CARD.

 

Sync Mode

MASTER, 
REMOTE, 
SLAVE

Specifies how the internal sequencer will operate and how MIDI Clock messages will be transmitted and 
received.

 

 The internal sequencer will synchronize to the internal tempo clock. Any MIDI Clock messag-

es received from an external device will be ignored.

 

 Operation will be essentially the same as “MASTER.” However, Start/Stop messages from 

the external MIDI device will control playback/stop for the internal sequencer.

 

 The internal sequencer will synchronize to MIDI Clock messages received from an external de-

vice. If no MIDI Clock messages are being received, pattern/song playback will not occur even if you 
press the [PLAY] button.

Sync Output

OFF, ON

Determines whether synchronization-related MIDI messages will be transmitted.

 

 Messages will not be transmitted.

 

 The following messages will be transmitted from the MIDI OUT connector.

• Timing Clock: F8
• Start: FA
• Continue: FB
• Stop: FC
• Song Position Pointer: F2

Arpeggio Sync 
Mode

OFF, 
MODE1, 
MODE2

Specifies how the arpeggio start timing will be synchronized to the pattern.

 

 The start timing will not synchronize.

 

 When a pattern plays, the arpeggio will start in synchronization. When the pattern stops, the 

arpeggio will also stop.

 

 In addition to the operation of MODE1, the arpeggio will start at the beginning of the next mea-

sure of the currently-playing pattern.

* If the pattern is stopped, the arpeggio will start immediately, regardless of which of the above settings 

is selected.

MC-909_Ref_e.book 127 ページ ２００５年３月１日　火曜日　午後３時２９分