Siemens TC12 사용자 설명서

 

TC12 Installation, Commissioning & Maintenance Handbook 

KLE = 0 or 1 
C

d) 

his 

command must always be used before enabling the LMU for the 
first time. 

GOL {Output b

omment:   Defines the function of the OTU hardware outputs. The output 

function is as described for the GRL command (see section 

 is direct from 

KRD = 1 

 Red lamp failure output. This is 

ime controllers that shut down when two red 

KRE {sensor number 1 - 23 } = { 0 or 1 } (0),  [ (1) for pre PB392 issue 2.] 

Comment:   To select normal lamp monitoring (i.e. not red lamp monitoring) on 

ch intersection vehicle 

RG {sensor number 1 - 23 } = { 00000000 - 11111111 } (0) 

Comment:   Enables la

ular sensor number to 

be allocated to one or more of eight monitor groups whose outputs 

p fault signals to UTC and the controller. Setting bit 

 to group 0 etc. 

KSS = {sensor

Comment:   For dual controller applications defines the input number to be used 

for the second controller lamp supply voltage transformer. 

omment:  

To enable or disable the Lamp Monitor facility (1 = enable

 

KLR = 1 

Comment:   Causes LMU to reset and relearn the lamp characteristics. T

 

it number: 0 - 15} = { Output function: 0 - 255 } (0) 

C

3.3.3.13 except those marked *). The normal default
the UTC control bytes. 

 

Comment:   Used to temporarily remove the 2nd

required to restart part t
failures occur. 

 

vehicle phases set this value to 0 for ea
sensor.  

 

K

mp faults associated with a partic

provide the lam
0 maps the sensor

 

 number 0 - 22 } (0) 

 

666/HE/43100/000  

Page 108 

Issue 9